Description
Instructions on how to setup die wood edge for flat die press in defaults and how the resulting wood edge will look like.
Procedure
Defaults for setting up die wood edge:
The following table illustrates how the new rotary wood edge functionality uses bottom allowance.
Settings | Reference Point | Resulting die wood edge |
Maximum or suggested size and Centered Die board check box is ON | X set to Center of Sheet Y set to Bottom of Sheet | X centered on Reference point Y centered on Layout Design |
Maximum or suggested size and Centered Die board check box is ON | X set to Center of Layout Design Y set to Bottom of Layout Design |
X centered on Reference point Y centered on Layout Design |
Maximum or suggested size and Centered Die board check box is OFF | X set to Center of Sheet Y set to Bottom of Sheet |
X centered on Reference point Y bottom aligned with Reference point |
Maximum or suggested size and Centered Die board check box is OFF | X set to Center of Layout Design Y set to Bottom of Layout Design |
X centered on Reference point Y bottom aligned with Reference point |
Specify Allowances and Centered Die board check box is ON | X set to Center of Sheet Y set to Bottom of Sheet |
X centered on Reference point Y bottom aligned with Reference point Die wood width calculated by layout plus left and right allowances, and then centered on Reference point. |
Specify Allowances and Centered Die board check box is ON | X set to Center of Layout Design Y set to Bottom of Layout Design |
X centered on Reference point Y bottom aligned with Reference point Die wood width calculated by layout plus left and right allowances, and then centered on Reference point. Even when right and left allowances are different after centered wood edge they look the same. |
Specify Allowances and Centered Die board check box is OFF | X set to Center of Sheet Y set to Bottom of Sheet |
X centered on Reference point Y bottom aligned with Reference point Die wood width calculated by layout plus left and right allowances, and then centered on Reference point. |
Specify Allowances and Centered Die board check box is OFF | X set to Center of Layout Design Y set to Bottom of Layout Design |
X centered on Reference point Y bottom aligned with Reference point Die wood width calculated by layout plus left and right allowances, and then centered on Reference point. Even when right and left allowances are different after centered wood edge they look the same. |
| Article information | |
|---|---|
| Applies to | ArtiosCAD 14.0 |
| Created | 15-Dec-014 |
| Last revised | |
| Author | Inessa Vengerik |
| CW Number | |