KB184715097: Which measurement conditions are supported by Color Engine Pilot and Color Pilot

Question

Which measurement conditions (http://www.xrite.com/service-support/M0M1M2andM3measurementconditions) are supported in Color Engine Pilot and Color Pilot?

Answer

Although the measurement conditions are part of an official standard (ISO 13655), only X-rite devices support them. While most measurement conditions are supported by the hardware that is not the case for the software. Here is an overview of the supported measurement conditions.

Color Engine Pilot versions compatible with the measurement conditions

Please note that measurement conditions are only supported since Color Engine Pilot 12.1.

Color Engine Pilot 12.1 and newer

	M0	M1 (D50)	M2 (UV-cut)	M3 (Pol)
i1Pro 1 / i1iO 1st generation (non UV)	v	-	-	-
i1Pro 1 / i1iO 1st generation (UV)	-	-	v	-
i1Pro 2	v	v	v	-
i1iO 2nd generation (*)	v	-	-	-
eXact – spot mode () (*)	v	v	v	v
eXact – scan mode () (*)	Scan mode not supported!
Barbieri Spectro Swing	v	-	-	-

(*) i1iO firmware 1.0.8 required!

(**) USB connection only, Bluetooth not supported!

(***) eXact only supported from Color Engine Pilot 14.0 onwards!

Color Pilot 16.1.1 and newer

	M0	M1 (D50)	M2 (UV-cut)	M3 (Pol)
i1Pro 1 / i1iO 1st generation (non UV)	v	-	-	-
i1Pro 1 / i1iO 1st generation (UV)	-	-	v	-
i1Pro 2 / i1iO 2nd generation (*) – spot mode	v	v	v	-
i1Pro 2 / i1iO 2nd generation (*) – scan mode	v	v (***)	v (***)	-
eXact – spot mode (**)	v	v	v	v
eXact – scan mode (**)	v	v (***)	v (***)	v (***)
Barbieri Spectro Swing	v	-	-	-

(*) i1iO firmware 1.0.8 required

(**) USB connection only, Bluetooth not supported!

(***) M1, M2 and M3 are only supported when creating a proofer and digital press profile, not when creating a press profile!

Article information
Applies to	Color Engine Pilot 12.1 and newer
Created	12-Jan-17
Last revised	31-Jan-18
Author	SDOB
Case Number

Contents