Child pages
  • KB192484173: Hotfix 201701007 for i-cut Layout 16.1
Skip to end of metadata
Go to start of metadata

Summary

When exporting a layout, the scissors icon has to be selected for the extra structural inks (ex. crease/drill, etc.) upon each export. To avoid it, there is now a preference option where one can specify a list of separation names (with wildcards). 

Release date

Monday, September 25, 2017

Symptoms

  1. Open i-cut Layout and create a new sheet.
  2. Add a file as a graphic.
  3. Find layouts.
  4. Export to production files.
  5. Cut is already set as a cut line on the Cut layer.
  6. The crease is set as a print ink.
  7. Change this to a cut ink and set the layer to crease.
  8. Files are exported correctly.
  9. Close i-cut Layout.
  10. Do steps 1 through 4 again. The crease line has to be changed again. This happens every time. In i-cut Layout 14.1 once the ink type and layer were set it did not have to be set every time.

System requirements

The standard system requirements for this product apply (for details, see the product pages on www.esko.com).

Dependencies

Makes hotfix 201701006, 201701004 and 201701003 obsolete

Installation Instructions

Close i-cut Layout and double click the hotfix installer.

Downloads

To download the hotfix, go to https://mysoftware.esko.com/Hotfixes/Details/201701007/16.0. 

Disclaimer

DISCLAIMER OF WARRANTIES: ESKO GRAPHICS BVBA (HEREINAFTER REFERRED TO AS "ESKO") DOES NOT GUARANTEE THAT YOU WILL BE ABLE TO SUCCESSFULLY DOWNLOAD OR IMPLEMENT ANY HOTFIX, PATCH OR SERVICE PACK, OR ANY OF THE TIPS, SAMPLES OR SUGGESTIONS DESCRIBED IN ANY ESKO PRODUCT SUPPORT DOCUMENTATION, INCLUDING KNOWLEDGE BASE ARTICLES. ALL ESKO TECHNICAL DOCUMENTS, HOTFIXES, PATCHES AND SERVICE PACKS ARE SUBJECT TO CHANGE WITHOUT NOTICE.

LIMIT OF LIABILITY: BY DOWNLOADING OR IMPLEMENTING THE HOTFIXES, PATCHES AND SERVICE PACKS YOU AGREE THAT ESKO HAS MADE NO EXPRESS WARRANTIES TO YOU REGARDING SAID ITEMS, AND THAT SAID ITEMS ARE PROVIDED TO YOU 'AS IS' WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL ESKO OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL LOSS OF DATA, OR LOST BUSINESS PROFITS OR SPECIAL DAMAGES, THAT MAY OCCUR AS A RESULT OF IMPLEMENTING A HOTFIX, PATCH OR SERVICE PACK OR WORKAROUND, OR ANY SUGGESTION OUTLINED IN ANY ESKO PRODUCT SUPPORT TECHNICAL DOCUMENT, EVEN IF ESKO OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Article information
Applies to

i-cut Layout 16.1

Created15-Sep-17
Last revised 
Author FBR
Case NumberCS00881913
Contents

What is a Hotfix?

A Hotfix is a software package that you can install on an existing installation of our software. Each hotfix contains fixes for one or more known issues in our released software.

Because there is always a small chance for a hotfix to cause new issues, you should only install Recommended Hotfixes, unless otherwise instructed by your Esko Software Support team.