Child pages
  • KB220236807: ArtiosCAD - Silent installer for patches or hotfixes
Skip to end of metadata
Go to start of metadata

Esko Confidential: This article contains confidential information and may not be distributed to persons outside Esko and its subsidiaries. Please check whether the label "esko-confidential" is present on this article before submitting it.

Description

The following steps will explain how to do the silent installation for ArtiosCAD patches or hotfixes.

Procedure

Here are the following command lines for applying hotfix or patches for ArtiosCAD:

  1. Make sure the patch or hotfix is downloaded. 

  2. Make sure the command prompt is running as an administrator and the directory is set to the path where the patch or hotfix is downloaded. 

  3. Enter the following command in the command prompt:(name of the patch or hotfix with the extension) /s /v" /qn REINSTALLMODE=omus REINSTALL=ALL" 
    Example: ArtiosCAD_18.0_bld1962to1993.exe /s /v" /qn REINSTALLMODE=omus REINSTALL=ALL"

Any other silent install options can be set, but it is not recommended except using /l to log. It is better to leave ArtiosCAD configured as-is when applying a patch or hotfix. However, ACADPatch.log gets created without this command, so it is not needed.

Article information
Applies to

ArtiosCAD

ArtiosCAD Enterprise

Created

 

Last revised

AuthorKYBA
Case Number
Contents