KB285553708: Hotfix 201911074 for Automation Engine 18.1.1

Summary

Step & Repeat Tabular (Dynamic): Re-opening a ticket that used SmartNames for "Cell Width" and/or "Cell Height" parameters, may show static values instead of these SmartNames.

Symptoms

When using SmartNames for the "Cell Width" and/or "Cell Height" parameters of the "Step & Repeat Tabular (Dynamic)" task, it may happen that re-opening the ticket of a launched task shows static values (as applied) for these parameters rather than the expected SmartNames themselves.

More Information

For installation instructions and to download the hotfix, go to https://mysoftware.esko.com/Hotfixes/Details/201911074/18.1.1.

Article information
Applies to	Automation Engine 18.1.1
Created	01 Jun 2020
Last revised
Author	MARN
Case Number	CS01220502, CS01270584

Contents

What is a Hotfix?

A Hotfix is a software package that you can install on an existing installation of our software. Each hotfix contains fixes for one or more known issues in our released software.

Because there is always a small chance for a hotfix to cause new issues, you should only install Recommended Hotfixes, unless otherwise instructed by your Esko Software Support team.