Esko Logo Back to Esko Support
Choose your language for a machine translation:
Skip to end of metadata
Go to start of metadata

 

Description

 When using i-cut to cut long lines on a pre-printed piece, the cut will wander from the print slightly. 

Procedure

i-cut determines where to cut based on triangulating each point on the layer in reference to the closest registration marks. Adding more points along long lines will make the cut more accurate.

  1. Select long lines with few points.
  2. Select Preparation, Optimize Curves.
  3. Check the Break long lines check box and type a value in the box. The smaller the value the better.
Article information
Applies to

Kongsberg XL

Kongsberg XN

Kongsberg XE

Kongsberg XP

Kongsberg C

Kongsberg  V

Created26-Mar-14
Last revised 
AuthorJEFR
Problemlog Number 
Contents