The following are the suggested system requirements for Digital Flexo Suite, PlatePrep and PlatePatcher. Exceeding these requirements will in most cases lead to a performance increase.
Intel processor - Core-i-Series (i7 or higher recommended)
Other processors like AMD or Intel Xeon are not tested and can lead to failures.
Minimum 8 GB RAM (16GB recommended)
Available hard drive space
An NTFS volume is required. The software takes about 600 MB of disk space. Also take into account the need for storage of temporary and production data. A backup solution is strongly advised.
Recommended hard drives: 1TB SSD.
Minimum 1280 x 1024 resolution, true color depth.
Recommended resolution: Full HD or higher
100/1000 Base-T Ethernet, TCP/IP v4 protocol
TCP/IP v6 protocol is not supported.
Minimum Version: Grapholas 14
Recommended Version: Grapholas 22.7
If the firewall is not disabled open the following ports IN and OUT:
If an operating system is not listed in the tables below, it is not supported. Do not try to install Digital Flexo Suite on a computer running an unsupported operating system.
Digital Flexo Suite
24 Oct 2022
Note: This is an anonymous survey. If you need help from Esko Support, register a Support Case here.