Esko Logo Back to Esko Support

Page History

Choose your language for a machine translation:

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Updated by Esko.Confluence integration from workflowwiki



Description

Instructions to setup a set up an HTTPS connection for the browser - based Automation Engine client.

Procedure

Prerequisites:

  • You will need an official SSL certificate from a recognized certificate authority to correctly configure the HTTPS connection. If you don't supply an official certificate, a self-signed certificate will be used. In that case, your browser will show an a warning that your connection is not secure because the authenticity of the certificate can not be verified.
  • Changing the connection settings requires a restart of the Job Server. When you do this, make sure that there are no tasks running on the Automation Engine Server.

 Proceed as follows:

  1. Import the certificate into the windows certificate store Windows Certificate Store for the Automation Engine system account. This By default, this user is called 'BGSystem by default'.
    Note: next The below steps will assume that the Automation Engine AE system account name is 'BGSystem. If not, replace BGSystem by the system account name.
    log '. When that is no longer the case, just replace 'BGSystem' in below steps with your custom name of your system account.
    1. Log in as user BGSystem and go to the Manage computer certificates control panel.
      Alternatively, you can launch the Manage User Certificates control panel when logged in as another user by following the next these steps:
      1. open Open a command prompt: type 'cmd' in the search field in the Windows Taskbar and press 'enter'
      2. enter Enter following command on the command prompt:   runas /user:BGSystem "cmd /c mmc certmgr.msc"
      3. enter Enter the password for the user BGSystem.
    2. In the left pane, navigate to the Personal > Certificates and right-click in Certificates ; choose . Choose All Tasks... > Import....
    3. Navigate to the location where the certificate is stored and follow the wizard.
    4. Once the wizard is finished, the imported certificate should show up in the list on the right. Make sure the the entry Personal > Certificates entry is  is selected.
    5. Check the column Friendly Name column for  for the imported certificate.
      • Take note of this name , ; it is used later on to configure Automation Engine later on.
      • If the the certificate has no Friendly Name then right-click the certificate > Properties.
      • On the first TAB tab General, the first input field is used to set the Friendly Name.
      • Apply and Close the dialog. Verify that the certificate now has the name set.
  2. Go to the Browser Based Client Tab on the localhost ServerAdmin pages.
    1. The localhost ServerAdmin pages can only be accessed from the Automation Engine Server machine. Default computer. This is by default  URL: http://localhost:9897
    2. Go to Server Config > Browser Based Client
  3. Select Use HTTPS.
  4. Select the Friendly Name from the list of SSL Certificates.
  5. It is recommended to disable http: deselect Use HTTP and optionally enable Redirect HTTP to HTTPS.
  6. Press Apply.




Article information
Applies to

Automation Engine 18.1.1 and newer

Created

 

Last revised

 

AuthorHAGE
Case Number


Panel
titleContents

Table of Contents
classinline-toc