Esko Logo Back to Esko Support

Page History

Choose your language for a machine translation:

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3

Summary

Uploading a CAD file in WebCenter fails. 

Symptoms

The upload fails and you get an error message: "Unable to get a real design type for x.ARD".

This is the case for almost all types of CAD files:

  • ARD
  • MFG
  • A3D
  • DXF
  • ...

Solution

Solution 1: Load Boards and Defaults for WebCenter

Mostly, a CAD file upload fails because the Boards and Defaults for WebCenter are not loaded.

You must load Boards and Defaults, even if you don't use this WebCenter as an ArtiosCAD Enterprise server.
If they are not loaded, it causes problems when using all types of CAD files.

Info

Refer to the installation guide to see how you can load the Boards and Defaults for WebCenter.

  • To load Boards: Configuring WebCenter > Configure WebCenter for Use with ArtiosCAD Enterprise > Step 2 - Running the Board Importer Batch File.
  • To load Defaults: Configuring WebCenter > Configure WebCenter for Use with ArtiosCAD Enterprise > Step 3 - Loading the Esko ArtiosCAD Defaults.
Solution 2: Run CAD-X

If solution 1 doesn't solve the issue, make sure that CAD-X is running:

  1. Start CAD-X.
  2. Try to upload the CAD file again.

 

Article information
Applies to

WebCenter all versions

Created17-May-13
Last revised23-May-13
AuthorHADW
CW Number162458
Panel
titleContents

Table of Contents
classinline-toc