Esko Logo Back to Esko Support
Choose your language for a machine translation:
Skip to end of metadata
Go to start of metadata

Summary

Automation Engine Client/ Pilot installed on Mac launches, but seems to lag. You can select the file and launch with the workflow but it takes 3-6 minutes for the task to show in the Task Monitor and start the workflow. The Automation Engine Client/ Pilot launches on other Mac computers and works fine. This problem is related to only one Mac computer.

Symptoms

Automation Engine Client/ Pilot lags and is slow. The Automation Engine PC could not ping the Mac by name (open Command window and  type ping MacName).

Solution

If the customer is using a DNS server, IT department should register the Automation Engine Server and the workstations in the DNS server (also reverse DNS should be done!).

Workaround

  1. First check if  there is a DNS server configured:
    1. Open the Command window on the Automation Engine Server.
    2. Type ipconfig/all.

      DNS Servers . . . . . . . . . . . : 10.31.231.35
                                          10.31.231.34
  2. If there is a DNS Server, check if the DNS Server is inside the LAN or outside the LAN.
  3. If the DNS Server is outside the LAN, go to step 5.
  4. If the DNS Server is inside the LAN, check if the computer is registered in the DNS Server:
    1. Open Command window.
    2. Type nslookup computername.

    3. If it is registered it will show name and address in the next line. If not it will show the name of the DNS Server and a message that the computername can't be found:

      nslookup  
      genll1111                                                                                                                                                       
       Server:  egwbedc003.esko-graphics.com
      Address:  10.31.231.35
       
      *** egwbedc003.esko-graphics.com
      can't find genl1111: Non-existent domain
  5. The workaround is to adapt the host file on the Automation Engine Server. 
  6. Modify the hosts with WordPad file on the Automation Engine Server.
    1. Browse to C:\WINDOWS\system32\drivers\etc.
    2. Right click the hosts file and open with WordPad.
    3. At the bottom of the file, add the IP address of the Mac then tab and add the Computer name of the Mac. The computer name on the Mac can be found in System Preferences > Network > Sharing.
    4. If the Automation Engine Server is not registered in the DNS, then add to the host file, the IP address and Name of the Automation Engine Server.

    5. On the Mac, add to the host file all IP addresses and names of the Mac workstations and the Automation Engine Server. Here is the explanation on how to edit the host file on Mac:


      DHCP is only allowed if the IP address is reserved!

Article information
Applies to

Automation Engine all versions

Created21-Aug-13
Last revised30-Jun-16
AuthorLMJ, HG
CW Number182899
Contents