Which Dot Clean-Up parameters are used when a printing condition is selected?
If you have made a printing condition in the Print Control Wizard, you can use it in the Image to Screened Separations ticket. A printing condition contains the optimal screen(s) and curve(s) to use for a production workflow.
When selecting a printing condition, Dot Clean-Up is activated in the Post-RIP tab. The values (Ruling and Minimum Dot Size) are defined by the Printing Condition. If the printing condition contains multiple screens, the highest ruling and lowest minimum dot size are taken.
When you use screens from the job that are not part of the Printing Condition (object based screening), it is possible that the Dot Clean-Up parameters are not optimal. An example is the use of AM screen (e.g. to avoid graininess). In that case, the minimum dot size should be adapted (lowered) to get a good result.
The minimum dot size defined in the printing condition is always expressed in pixels. The number is the total number of pixels that comprise the minimum dot. Screen dots smaller than the defined minimum dot size will be removed, while small dots that are used for support or as part of a screen’s surface effects will be retained.
If you want to set a minimum dot size as a percentage or a value expressed in microns, you can change the units. When changing the unit, the value is automatically converted.
|The size in microns refers to the diameter of the dot.|
When you enter a value different from the ones defined in the Printing Condition (Ruling or Minimum Dot Size), a warning is shown:
When the printing condition is set via a SmartName, the values (Ruling and Minimum Dot Size) are not shown because they are only resolved when the printing condition got resolved during the execution of the task.
The value for ruling and/or minimum dot size can still be overruled.
During RIPping, all output pixels dots whose size is smaller than the specified minimum dot size are removed. In case multiple screens are used with different minimum dot sizes, the lowest minimum dot is used to clean-up. This is done automatically. If you want to know which dot clean-up parameters are really used, then check the details window of the task:
Dot clean-up parameter for Cyan: support dot size 5 Dot clean-up parameter for Cyan: min dot size 19 Dot clean-up parameter for Cyan: WSI Microcell screening, min WSI dot pixels 19 Dot clean up: The requested minimum dot size (15 pixels) is different from the value derived from the screens (19 Pixels). The smaller value will be used.
The task finishes with a warning in following cases:
Imaging Engine 16.1.1 and newer