KB180109960: ArtiosCAD - How to configure Artios so that cut and crease line gets a full crease and a set of cuts on a Kongsberg table

Description

Where is the trick that a perforation-line gets translated into one line that is creased and a lot of small lines that get cut?

Procedure

In your design, use a line of the type Cut and Crease and make sure the output settings are set correctly:

• to verify/modify your output on the fly: open the Properties window of your output dialog.
• to verify/modify your output permanently: open Defaults > Outputs > your Kongsberg output.

• Make sure your Output Type is set to Sample.
  
   
• Click the Sample Line Types tab.
• Make sure the choice for Cut and Crease is set to Crease then sequence of cuts.
• Also make sure that the Perf cut back value is less than your gap length.