Esko Logo Back to Esko Support
Choose your language for a machine translation:
Skip to end of metadata
Go to start of metadata


Check Job Parameters: add proper support for the screen 'MFOLD', after being renamed from 'MF'.


  • Automation Engine tasks (i.e the "Check Job Parameters" task) did not support the MFOLD screen properly even after its rename from MF to MFOLD. These tasks revert (without warning or error) to the default screen.
  • Curve Pilot: Dot MFOLD was not in the default list of dotshapes. It could be added manually, but that had to be redone every single time.

More Information

For installation instructions and to download the hotfix, go to:

Article information
Applies to

Automation Engine 16.1.1

Curve Pilot 16.1.1



Last revised 
Case NumberCS01005159 

What is a Hotfix?

A Hotfix is a software package that you can install on an existing installation of our software. Each hotfix contains fixes for one or more known issues in our released software.

Because there is always a small chance for a hotfix to cause new issues, you should only install Recommended Hotfixes, unless otherwise instructed by your Esko Software Support team.