KB339370593: HOTFIX 202011023 for Automation Engine 20.1

Summary

Job Parameters: After a job is created and/or updated from JDF, adapting a job parameter may sometimes not work properly.

Symptoms

After a job is created and/or updated from JDF, both adapting a job parameter in the Pilot or running a "Create Job" task to do so, may fail with below message:

"A problem occured while saving the job parameters." (Pilot)
"…SQLServerException: The value is not set for the parameter number 5." (task & Pilot)

More Information

For installation instructions and to download the hotfix, go to https://mysoftware.esko.com/Hotfixes/Details/202011023/20.1.

Article information
Applies to	Automation Engine 20.1
Created	06 Oct 2021
Last revised
Author	PVE
Case Number	CS01423231

Contents

What is a Hotfix?

A Hotfix is a software package that you can install on an existing installation of our software. Each hotfix contains fixes for one or more known issues in our released software.

Because there is always a small chance for a hotfix to cause new issues, you should only install Recommended Hotfixes, unless otherwise instructed by your Esko Software Support team.