Child pages
  • KB78612952: Hotfix 78 for i-cut Layout 12.0
Skip to end of metadata
Go to start of metadata



Minimal waste and minimum layouts nesting modes could result in overlapping cut paths.


True shape nesting, in some rare cases (for example: when the scale factor is more than 250), the graphics could overlap.

More Information

For installation instructions and to download the hotfix, go to:

Article information
Applies to

i-cut Layout 12.0

Last revised 
Author FBR
CW NumberEA169601

What is a Hotfix?

A Hotfix is a software package that you can install on an existing installation of our software. Each hotfix contains fixes for one or more known issues in our released software.

Because there is always a small chance for a hotfix to cause new issues, you should only install Recommended Hotfixes, unless otherwise instructed by your Esko Software Support team.